Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
&
WARNING:TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
"
Depress brake pedal fully and set parking brake.
"
Place attachment clutch in"DISENGAGED"
position.
"
Turn ignition key to"STOP" and remove key.
"
Make sure the blades and all moving parts have completely stopped.
"
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
(See Fig. 18)
•
Place attachment clutch in "DISENGAGED"
position.
•
If equipped, turn height adjustment
knob to lowest
setting.
•
Lower mower to its lowest position.
•
Disengage belt tension rod from lock bracket.
I
CAUTION: Rod is spring loaded. Have a
I
tight grip on rod and release slowly.
I
•
Remove retainer spring holding anti-swaybar to chassis
bracket and disengage anti-swaybar from bracket.
•
Remove four retainer springs from front plate assembly
and remove plate.
•
Remove retainer springs from suspension arms at deck
and disengage arms from deck.
•
Raise attachment lift to its highest position.
•
Slide mower forward and remove belt from electric
clutch pulley.
•
Slide mower out from under right side of tractor.
TO INSTALL
MOWER
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage park-
ing brake.
•
Swing anti-sway bar to left side of mower deck.
•
Slide mower under tractor with deflector shield to right
side of tractor.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL
MOWER PULLEY GROOVES.
•
If equipped,
turn height adjustment
knob counter-
clockwise until it stops.
•
Lower mower linkage with attachment lift control.
•
Be sure belt tension rod is in disengaged position.
•
Install belt into electric clutch pulley groove.
•
Place the suspension arms on outward pointing deck
pins. Retain with double loop retainer spring with loops
up as shown.
•
Install front plate assembly
to tractor
suspension
brackets and retain with single loop retainer springs
as shown.
SUSPENSION
ARMS
BELTTENSION
ROD _/?
(DISENGAGED
POSITION)
',
//
CHASSIS
BRACKET
RETAINER
SPRING
LOCK BRACKET
FRONT
MOWER
BRACKET
\
ELECTRIC CLUTCH PULLEY
FRONT PLATE
ASSEMBLY
SINGLE LOOP
RETAINER
SPRING
DOUBLE LOOP
RETAINER
SPRING
FLANGED PIN
ANTI-SWAY
BAR
SUSPENSION
ARMS
DOUBLE LOOP
RETAINER SPRINGS
(Outward pointing
deck pins)
o
DEFLECTOR
SHIELD
FIG. 18
20
Advertisement
Table of Contents
Troubleshooting
