Accessories; Remote Control Operations - Pioneer LaserDisc CLD-S104 Operating Instructions Manual

ACCESSORIES
........ r
When unpacking the player, first check to make sure that all of the accessories listed below are supplied.
Remote control unit
Size "AAA"(IEC R03) [_1
dry cell battery x 2
(CLD-S370/CLD-S304)
Size 'AA" (IEC R6P)
dry cell battery x 2
(CLD-S270/CLD-S104)
__ CLD-S370/
CLD-S304
@
CLD-S270/
CLD-S104
;To open the cover of the remote control unit
(CLD-S370/CLD-S304)
Hold both sides of the cover
and lift it up.
• Audio cord
(Pin plug x 2 *---* Pin plug x 2)
Use to connect the player to a stereo amplifier etc.
• Video cord
(Pin plug *---* Pin plug)
Use to connect the player to a color monitor etc.
• Operating instructions
• Warranty card
REMOTE CONTROL OPERATIONS
INSERTING BATTERIES INTO THE REMOTE
CONTROL UNIT
Open the battery compartment cover on the back of the
remote control unit.
Insert dry cell batteries into the battery compartment in
accordance with the indications ((_) , _) ) inside the
compartment.
Close the cover of the battery case.
CLD-S370/CLD-S304
O @ ®
Remote controllable range
Angle: Within 30 degrees to the left and right of the center line
Distance: Less than 7 m (23 ft)
CLD-S270/CLD-S 104
Incorrect use of
batteries may cause leakage or rupture.
Always be sure to follow these
guidelines:
A. Always insert batteries into the battery compartmet
correctly matching the positive _) and negative _ polarities,
as shown by the display inside the compartment.
B. Never mix new and used batteries.
C. Batteries of the same size may have different voltages,
depending on brand. Do not mix different brands of batteries.
When the unit is not to be used for a long period of time (more
than one month), remove the batteries to prevent them from
leaking inside the compartment. If leakage occurs, wipe up
the liquid inside the compartment and replace the batteries
with new ones.
NOTES FOR USING THE REMOTE CONTROL UNIT:
• Ifa plug is connected to the CONTROL IN terminal at the
rear of the player, remote control operations cannot be
done with the remote control unit aimed at the player's
remote control sensor. In this case, aim the remote control
unit at the remote sensor of another controlled component
instead for the remote control operation.
• If the player is used simultaneously with anotherappliance
using infrared rays, the player may operate improperly.
£hould this happen, change the place o{in_tallatlon so that
improper operation does not ocour.
• Jftherangeofoperationoftherem°tec°ntr°lunitbec°mes
too short, replace the batteries.
• If the remote control sensor window is in a position where
it receives strong light such as sunlight or fluorescent light,
control may not be possible.
5
<VRB1143>