Table of Contents
Advertisement
Connecting
Your TV
4. Drill holes in cabinet
• Drill I/4-ineh diameter holes through the underside of the cabinet bottom using the
five circles on the mounting guide as a guide.
5. Remove mounting guide and drill shavings
Remove the mounting guide and clean the drill shavings from inside and under the
cabinet.
6. Sdect spacers if required
• The spacers slip over the ends of the screws and allow you to mount the TV below
the edge of the cabinet's overhang.
• If your cabinet does not have an overhang, you probably will not need to use any
spacers.
• If your cabinet has an overhang, select the proper length spacer(s) so the TV will
clear the overhang when swiveled.
• Two or three spacers can be used together to make lengths of 1/4" to 1-3/4" at 1/4"
increments. Refer to the chart below to select the proper spacers:
7. Select proper length of screws
• Only five screws are needed. The size you need depends upon your type of cabinet.
• Holding the selected spacers for one of the screw holes under the cabinet, install a
washer and screw inside the cabinet using one of the three lengths of screws
provided.
Note: A visual description of these parts is on page 2.
Less than 1"
None Required
1" to 1-1/4"
1/4" Spacers
1-1/4" to 1/2"
1/2" Spacers
1-1/2" 1-3/4"
3/4" Spacers
1-3/4" to 2"
1" Spacers
3/4"
8. Position mounting bracket under cabinet
• Position the mounting bracket under the cabinet as shown and match the screw
holes.
9. Attach mounting bracket to cabinet
• First mount one corner of the bracket. Hold the bracket and spacer(s) in place and
insert the screw from the inside of the cabinet down through washer and drilled
hole or down through countersink and drilled hole.
Note: The washers must be usedon metalcabinetsand on woodcabinetsif you do not
countersinkthe drilledholes.
• Position the washer fiat-side down and place screw into screw hole, through the
spacer(s) and through the screw hole in the mounting bracket.
• Place a nut into the cylinder at the bottom of the mounting bracket screw hole.
Hold nut in place (if necessary, use the top of a pencil). While maintaining upward
pressure on the mounting bracket, finger tighten the screw. Do not tighten firmly
until all five screws have been started.
• Align each of the remaining mounting bracket screw holes with the drilled holes
and properly position the selected spacers. Install washers, screws, and nuts as
previously described. Now, finish tightening the five screws but do not overtighten
them.
• -,..
.,,
"
•
_.
"
....
-:::_
: " "" : .:':
.:_.'"
":
...'V.'i_";:.:.':=.':;
;=_'::'
-
".:-.,'---::_':_.'..-,."..-(:.:=.-::'7_:_:_.!," :::: "::
_fion:
If the:_V_!m0
_it:w_l
not_w
_he
n_ far enoi_gt_:to _::
eouldltititwbeniswiveled.:
_: :,
.....
:
: =:_,:::::
................
..
.........
. .........
:.
......
.
...
•
1/4"to 3/4"for
ProperMounting
:
_8
Advertisement
Table of Contents
