Mitsubishi Electric 3D DLP 642 series Owner's Manual page 32

32 Appendices
Appendix B: Troubleshooting, continued
matically (Timer function)
® The clock may not be set.
paneUstarted to bUink, to prevent damage. Wait for the green Uightto stop flashing
and turn the TV on again.
• Rfthe TV does not stay on, press the POWER button on the
control paneUfor ten seconds to perform System Reset. Rf
this happens frequently, obtain an AC Uinepower condi-
tioner/surge protector.
An unusual digital signal may have been received, triggering a
protection circuit. Wait for the light to stop flashing and turn TV
on. :_
4. TV will not power off. Press the POWER key on the control paneUfor ten seconds to
perform System Reset.
1. The picture does not Uook Uikea high-defini-
tion picture.
Not aHsignaUs are high-definition signaUs. To receive high-defini-
tion programming from your cable or satellite provider, you must
subscribe to the provider's high-definition service. Some over-
the-air broadcasts are in high-definition and can be received with
a high-quality antenna suited to your Iocation_
41 VCRorSV5 piayer;son[screen menus jitter Stop playback. Possible cause: ManyVCRs and DVD players
iii
up and down. provide on-screen menus at only half-resolution that may appear
} to jitter up and down.
rolling on the screen.
Begin playing the tape.
Change the VCR input from Line 1 to the VCR antenna input.
torted when viewed on the TV. the picture from a computer because the correction process
may cut off the edges of the image.
The aspect ratio may be wrong for the image. Press FORMAT
to change.
For assistance call 1(800) 332=2119