Mitsubishi Electric Mr.Slim MSZ-FD09NA Operating Instructions Manual page 6

• OPERATING INSTRUCTIONS •
Setting the installation position
Be sure to set the slide switch inside the remote controller in accordance with
the installed position of the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the left
Center: Distance to objects (wall, cabinet, etc.)is more than 19-11/16 in. (50
cm) to the left and right
Right: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
(Left) (Center) (Right) Slide switch
Slide switch
L.C.R
L.C.R
L.C.R
Remote controller
display r-_} _ _}"-i
i-see
Press <> during COOL mode to activate i-see control
operation._
• Press gently using a thin instrument.
• _ lights. (Operation display section)
i-see
Press © again to release i-see control operation.
The sensors constantly measure the room and
floor/wall temperature to automatically adjust to
the set temperature by estimating the tempera-
ture actually perceived by a person inside the
room ("sensible temperature").
i-see
sensor
When the AREA setting is not activated, the sensing range of the i-see sensor
differs depending on the installation location of the air conditioner.
Sensing range
i[i}i}iii_i_lii_i_lii_i_lii_i_lii_i_li !_i!!iiii}!_i}!_i}!_i}!_i}!_i}!_i}!!iiii[_}_}iii_i_ii_i_ii_i_ii_i_;_;_;_;_;_iii;i!i_i;i!i_i;i!i_i;i!i_i;i !
Note:
Do not touch the i-see sensor. This may cause malfunction of the i-see sensor.
AREA
Press _ to select AREA. Each press changes
AREA in the following order:
N _ '_ _ '_ _ '_i'Ca cel N
(AUTO) (Left) (Right) *_
• The i-see control operation has to be active to select AREA.
WIDE V ANE
• Horizontal airflow direction _ cannot be selected when AREA is
set. WIDE VANE
"1 Horizontal airflow direction set by _.
AREA
Press _ until "Cancel" is selected to release AREA
setting. W_DEVA,NE
• Pressing _ also releases AREA setting.
(AUTO) ....The i-see sensor detects temperature disparities, efficiently
cooling and heating the whole room.
In COOL mode:
(LEFT) / L_(RIGHT)
Select the desired area to be air conditioned.
Indoor unit display
Horizontal airflow direction:
Left Center or Swing Right
L--AREA--R L--AREA--R L--AREA--R
i',m} Lighted O Not lighted
En-5