Transporting Your Washer; Reinstalling/Using Washer Again - Maytag MVWC400XW4 Use And Care Manual

TRANSPORTi NG YOU R WASH ER
1. Shut off both water faucets, Disconnect and drain water
inlet hoses,
2. [f washer wiJ[ be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect drain from drain system and drain any
remaining water into a pan or bucket, Disconnect drain
hose from back of washer,
4. Unplug power cord,
5. Place inlet hoses and drain hose inside washer basket,
6. Drape power cord over edge and into washer basket,
7. Place packing tray from original shipping materials
back inside washer, if you do not have packing tray,
place heavy blankets or towels into basket opening.
Close lid and place tape over lid and down front of
washer. Keep lid taped until washer is placed in new
location,
REINSTAI.MNG/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage, or
moving:
1. Refer to "installation instructions" to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses, Reconnect water inlet hoses,
Turn on both water faucets,
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. PJug in washer or reconnect power.
3. Run washer through BULKY cycle to clean washer and
remove antifreeze, if used. Use only HE High Efficiency
detergent. Use 1/2 the manufacturer's recommended
amount for a medium-size load.
11