Payne PG9MXA Series Owner's Manual page 7

NOTE: If washable filter that was shipped with the furnace has
been replaced by:
• Factory specified disposable media filter--Do not clean.
If dirty, replace only with media filter having the same
part number and size. Install with airflow direction ar-
row pointing towards blower.
• Electronic Air Cleaner (EAC), refer to the EAC Owner's
Manual for maintenance information.
5. If washable filter, wash filter (if dirty) in a sink, bathtub, or
outside with a garden hose. Always use cold tap water. A
mild liquid detergent may be used if necessary. Spray water
through filter in the opposite direction of airflow. Allow fil-
ter to dry.
6. Reinstall clean air filter.
7. Reinstall filter retainer (for blower compartment locations
only.)
8. Replace blower access panel and main furnace door or
filter cabinet door. (See Fig. 15).
9. Turn on electrical supply to the furnace.
If your furnace air filter needs to be replaced, be sure to use a
factory-authorized filter of the same size that was originally
supplied. Use the filter table and compare your furnace size with
the proper filter size.
Fig. 12 - Slide Filter Out (Bottom Inlet)
A93011
A93012
Fig. 13 - Release Filter Retaining Rod (Side Inlet)
Fig. 10 - Blower Access Panel
A93204
A93013
Fig. 14 - Slide Filter Out of Furnace (Side Inlet)
A93010
Fig. 11 - Release Filter Retaining Rod (Bottom Inlet)
Fig. 15 - Replace Blower Access Panel
A93205