Operation - Technics SA-GX350 User Manual

Use t he
remote control within 60 degrees and within 7 meters (23
ft.) facing directly toward the receiver's remote control signal
receptor.
J
I I
About 7 meters in front of the
sensor
(The actual range will depend on
the angle at which the remote
control is used.)
Operation notes
Aim the remote control's transmission window toward the unit's
sensor. Avoid any obstacles.
rm
Avoid dust Avoid dust
Be sure the transmission window and the unit's sensor are free
from dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another
strong light source strikes the receiving sensor of this unit. If
there is a problem, place the unit away from the light source.
When operating a TV, VCR or a CD changer (or CD player) with a
remote control sensor, face this remote control toward the
remote control sensor of the unit to be operated.
This remote control transmitter can be used to operate units
manufactured by this company other than this receiver unit, in-
cludingCD changers (or CD players), tape decks and also TVs
and VCRs manufacturedsince 1985.
Preparations before use
Check the appropriate connection of the power cords and con-
nection cables for the remote control in order to operate CD
changers (or CD players) and tape decks correctly. (See page 8
of the operating instructions for the main unit.)
If the connectionsare made as Shownon page 8 and the power
supplyswitchesof each unitare set to ON, the power supplyfor
each unit will simultaneouslyturn ON and OFF when the power
supplyof the receiver is turned ON and OFF.
When operating the CD changer (or CD player),"IV or VCR,
the remotecontrolsignalmay fail to operatethe unit,even if it
is manufactured by this company,because of the nature of
the remote control signal. In such cases, switch over the
remote control signal by the following method.
Depending on the model, there may be cases where opera-
tion is still not possible even if the remote control signal is
switched over due to differences in frequency range
characteristics.
For CD changer (or CD player) operation
Press POWER and CD simultaneously, hold
CD
for 2 seconds.
For TV operation
Press POWER and TV simultaneously, hold
TV
for 2 seconds.
For VCR operation
Press POWER and VCR simultaneously,
_ hold for 2 seconds.
To restore the previous memory contents, carry out the
same operationsone more time.