Download Print this page

Technics SA-GX350 User Manual

Av control stereo receiver; how to use the remote control transmitter
Hide thumbs Also See for SA-GX350:

Advertisement

Quick Links

\
Technics
How to use the remote
controltransmitter
A V control stereo receiver
SA-GX350
Insert the batteries
include(
Check the (+)
and (-)
sides.
When you need to replace these batteries
Use two UM-4 "AAA", IEC R03 (1.5 V) or equivalent batteries.
When you remove the batteries
Press the (-)
side.
[_--_
Printed in Japan
Use
of batteries
Do not mix old and new batteries,
or batteries
of different
types
(carbon and alkaline, etc.).
Always remove
old, weak or worn-out
batteries
promptly
and
dispose of them properly.
The battery life is about one year.
Although
the battery
life varies depending
on how often
the
device
is used, the batteries
should
be replaced
about once
every year on the average.
The batteries should be replaced if commands
from the remote
control transmitter
do not operate the unit even when transmitter
is held close to the front panel.
Never subject batteries
to excessive
heat or flame; do not at-
tempt to disassemble
them; and be sure they are not short-cir-
cuited.
If the remote control is not to be used for a long period of time,
remove the batteries
and store them in a cool, dark place.
If a battery leaks, remove all batteries
and dispose of them pro-
perly. Thoroughly
clean the battery
compartment
before inser-
ting new batteries.
If the electrolyte
comes
into contact
with skin or clothes, flush
with water immediately.
Keep batteries out of reach of children.
Do not use rechargeable (nickel-cadmium) type batteries.
Do not attempt to recharge
alkaline or carbon batteries.
RQT1930-P
H1292C0

Advertisement

loading

Summary of Contents for Technics SA-GX350

  • Page 1 Insert the batteries include( Technics Check the (+) and (-) sides. How to use the remote When you need to replace these batteries Use two UM-4 "AAA", IEC R03 (1.5 V) or equivalent batteries. controltransmitter When you remove the batteries...
  • Page 2: Operation

    Use t he This remote control transmitter can be used to operate units remote control within 60 degrees and within 7 meters (23 manufactured by this company other than this receiver unit, in- ft.) facing directly toward the receiver's remote control signal cludingCD changers (or CD players), tape decks and also TVs receptor.
  • Page 3 After carrying out the operation on the reverse page for turning the power of the TV or VCR ON or OFF, always press TUNER before pressing POWER when turning the power of the receiver ON and OFF. Technics To listen to radio broadcasts Specify the preset channel using the numeric buttons.
  • Page 4: Sequential Play

    Repeat the steps (1)--(4). Technics CD+10 Select the desired track number. (4) Delete play (only for a Technics CD changer with delete play function) 9 r,V_FJ pROGRAM MODE Selecting the desired disc(s) is only ap- plicable to a Technics CD changer. Select Select the desired disc.
  • Page 5: Video Tapes

    To watch broadcasts To watch TV broadcasts with a VCR tuner Facing toward the TV Facing toward the VCR Facing toward the receiver Set the WNIDEO VCR t TV to "VIDEO". modeonthe Switch ON the Switch ON the power for TV. power for VCR.
  • Page 6 Problem Probable cause(s) Suggested remedy Remote control transmitter Batteries are incorrectly installed. • Insert the batteries so that the positive (+) and does not function, negative (-) polarities are correct. The remote control transmitter batteries are • Replace them with new batteries. drained.