Table of Contents
Advertisement
How to Use the Reversible,Inlet Grille
1. If you want to pull out the filter upward,
open the inlet grille slightly. Turn inside out
the front grille.
Disassemble
the inlet grille from the front
grille with separating
the hinged part by
inserting a "--" type screw-driver
tip.
Rotate the inlet grille 180 degrees
and
insert the hooks into the lower holes of front
grille
Then, insert the filter. (See Fig.12, 13)
2 A_ach the front grille to the cabinet by
inserting
the tabs on the grifle into the tabs
on the front of the cabinet,
Push the grille in
until it snaps into place
(See Fig.14)
!
7
Fig. 12
Fig, 13
3. Lift the inlet grille and secure it with a type
A screw through
the front grille.
(See Fig. 15)
4 if you want to pull out the filter downward,
use the reversible
inlet grille without
change.
(The grille is already assembled
for that
way.)
Bectrical Data
Fig, 14
Fig. 15,
Line Cord Plug
Use Wall Receptacle
Power Supply
....... _
l[)o
r_ot ur'der ar_Y
_T J
z/
circumstances out
-./.._
or remove the
Use
15 AM P time
>-_J
I grounding prong
delay fuse or circuit
[..from the plug,
i
breaker.
Power supply €oid with
3oprong grounding plug
USE OF EXTENSION CORDS
Because of potential safety hazards, we strongly discourage the use of an extension cord_However, if you wish to
use an extension cord, use a CSA certifiediUL-listed 3-wire (grounding) extension _rd, rated 15A, i25V.
Standard 125V, 3-wire grounding
r_eptacle
rated 15A, 125V AC
Advertisement
Table of Contents
