LG WT5101HW Owner's Manual page 30

TROU [ES OOTING
BEFORE cALLiNG FOR SERVicE (cont.)
washer won't Control panel is asleep • This is normal. Press POWER.
operate Washer is unplugged • Make sure cord is plugged securely into a working outlet.
Water supply is turned off • Turn both hot and cold faucets fully on.
Controls are not set • Make sure the cycle was set correctly, close the lid and
properly press START.
Lid is open-safety feature • Close lid and reset cycle, to the beginning if necessary.
Prevents the washer from
filling and operation when
lid is up
Circuit breaker/fuse is • Check house circuit breakers/fuses. Replace fuses or reset
tripped/blown breaker. The washer should have a dedicated circuit.
Electronics need to be • Press the POWER button.
reset
START was not pressed • Press START.
after a cycle was set
Extremely low water • Check another faucet in the house to make sure that
pressure household water pressure is adequate.
Washer is too cold • If the washer has been exposed to temperatures below
freezing for an extended period of time, allow it to warm
up before pressing POWER. Otherwise, the display will not
come on.
Washer not filling Filter clogged or fill hoses • Make sure that filters (blue and orange screens must be
property may be kinked free of solids) on the unit are not clogged. Turn off water
and check filter by disconnecting hose at machine. Check
that fill hoses are not kinked or clogged.
Energy efficiency • This is an energy-efficient washer. As a result the
temperature settings for this washer may be different than
non-energy-efficient washers.
insufficient water supply • Make sure that the water supply is turned on.
Make sure that the water faucets are turned to their
completely open positions.
The washer lid is open • The washer lid must be closed for all washer cycle
operations. If the lid is opened during washer operation, all
functions will stop, including water filling.
Incorrect fill hose • Make sure that the fill hoses connect the hot water supply
connection to the hot inlet on the washer, and the cold water supply to
the cold inlet on the washer (hot to hot, cold to cold).
Water fill optimization • Water may not cover the top level of the clothes. This
is normal for this high-efficiency washer. The water fill is
optimized by the system for best wash performance.
50