PROGRAMMING THE REMOTE CONTROL
The remote is a multi-brand
or a universal remote. It can be programmed
to operate most remote-control-
lable devices of other manufacturers.
Note that the remote may not control
all models of other brands.
Programming a code into a remote mode
II
To find out whether your remote control
can operate each device without
programming,
turn on the device
(such as a VCR) and press the corresponding
mode button on the remote.
After that, press the POWER button.
If the device is turned off and it responds properly
the remote control
need not be programmed.
If not, the remote should be programmed
to operate the device. The program-
ming procedures
are explained below.
O
Press the MENU and MUTE button continuously
at the same time for two seconds; the currently
selected
device button
is illuminated.
If you don't
press any button
for 20 seconds, the light on the mode button will be turned off. In that case,
you have to repeat from step 2.
O
Enter the appropriate
code from the code table on the following
pages. When pressing the button, the light
blinks at a time.
If the device turned off, the programming
is successful.
O
Press the MENU button
to store the code. After blinking twice, this code is stored.
O
Test the remote control
functions
to see if the device responds
properly. If not, steps 2-5.
m
z
_D
x
104