Craftsman 247.88955 Operator's Manual page 21

6. Remove the belt a sfollows. Refer toFigure 25.
a. Loosen and remove the shoulder screw w hich a cts a sabelt
keeper.
b. Unhook the support bracket spring f rom the frame.
7. Remove the belt f rom around the auger pulley, and slip the belt
between thesupport bracket and the auger pulley. See Figure 26.
8. Reassemble auger belt b yfollowing instructions inreverse order.
9. Perform t he Auger Control test o utlined inthe Assembly section
ofthis manual.
NOTE: DoNOT f orget toreinstall the shoulder screw and reconnect
the spring tothe frame a fter i nstalling areplacement auger belt.
Drive Belt
Toremoveand replaceyoursnow thrower'sdrivebelt, proceedas
follows:
1. Topreventspillage,removeall fuel fromtank by runningengine
untilit stops.
2. Removetheplasticbelt coveron the front of the engineby remov-
ing the two self-tappingscrews.See Figure22 on previouspage.
3. Removethebelt as follows.Referto Figure27.
a. Rollthe auger beltoff theengine pulley.
b. Use a wrenchto pivotthe idlerpulleytowardthe right.
c. Lift the drivebelt off enginepulley.
/" }
Figure25
Figure26
21
Figure27