Media Card Reader; Removing The Media Card Reader; Replacing The Media Card Reader - Dell Inspiron 560 Service Manual

3. Slide the hard drive into the hard-drive bay.
4. Align and replace the four screws that secure the hard drive to the drive panel.
5. Connect the power cable and the data cable to the hard drive.
6. Check all cables to be certain that they are properly connected and firmly seated.
7. Replace the computer cover (see
8. Connect your computer and devices to electrical outlets, and then turn them on.
9. See the documentation that came with the hard drive for instructions on installing any software required for hard drive operation.
10. Check the System Setup for hard drive configuration changes (see
Media Card Reader

Removing the Media Card Reader

1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the front bezel (see
4. Disconnect the FlexBay USB cable from the system board connector (see
5. Remove the two screws that secure the Media Card Reader to the drive panel.
6. Slide the Media Card Reader out through the front of the computer.
1 FlexBay USB cable 2 Media Card Reader (not present on all computers)
3 screws (2) 4 drive panel

Replacing the Media Card Reader

1. Follow the procedures in Before You
2. If this is a new Media Card Reader installation, remove the break-away metal plate. Align the tip of a Phillips screwdriver with the slot on the break-
away metal plate and rotate the screwdriver outwards to break and remove the metal plate.
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Removing the Front Bezel).
Begin.
Entering System Setup).
System Board Components).