Dell Inspiron 535 Service Manual page 15

4 processor cover 5 center cover latch
7 socket 8 tab
Inspiron 546
1 socket 2 processor pin-1 indicator
3 processor 4 release lever
4. For Inspiron 535/537/545, orient the front and rear alignment-notches on the processor with the front and rear alignment-notches on the socket.
5. Align the pin-1 corners of the processor and socket.
CAUTION: To avoid damage, ensure that the processor aligns properly with the socket, and do not use excessive force when you install the
processor.
6. Set the processor lightly in the socket and ensure that the processor is positioned correctly.
7. When the processor is fully seated in the socket, close the processor cover, if applicable.
Ensure that the tab on the processor cover is positioned underneath the center cover latch on the socket.
8. Pivot the socket release lever back toward the socket, and snap it into place to secure the processor.
9. Clean the thermal grease from the bottom of the heat sink.
CAUTION: Ensure that you apply new thermal grease. New thermal grease is critical for ensuring adequate thermal bonding, which is a
requirement for optimal processor operation.
10. Apply the new thermal grease to the top of the processor.
11. Replace the processor fan/heat sink assembly (see
CAUTION: Ensure that the processor fan/heat sink assembly is correctly seated and secure.
12. Replace the computer cover (see
Back to Contents Page
6 processor
9 release lever
Replacing the Processor Fan and Heat Sink
Replacing the Computer Cover).
Assembly).