Setting Up The Monitor; Connecting Your Monitor; Connecting The White Dvi Cable; Connecting The Blue Vga Cable - Dell S2409WFP User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ S2409W Flat Panel Monitor User's Guide
Connecting the Monitor
Organizing Your Cables
Attaching the Soundbar (optional)

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with
appropriate video systems.

Connecting the white DVI cable

Connecting the blue VGA cable

NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.
After you have completed connecting the DVI/VGA cable, follow the procedure below to complete your monitor setup:
1. Plug the power cables for your computer and monitor into a nearby outlet.
2. Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not display an image, see
3. Use the cable management slot on the monitor stand to organize the cables.

Organizing Your Cables

safety instructions.
Solving Problems.