Yard-Man 31AH763G401 Operator's Manual page 7

Adjust skid shoes as follows:
• Loosen, but do not n.-.move,the two hex nuts which
fasten the skid shoe to the auger housing,
° Raise or lower the sldd shoe to desired position.
• Retighten the hex nuts loosened earlier.
° Repeat on the other side of the snow thrower.
"Z" End _
Jam Nut
J
Auger Control
Cable
Figure 7
• Recheck adjustment; readjust as necessary and
tighten the jam nut.
Skid Shoe
The space between the shave plate and the ground can
be adjusted by repositioning the skid shoes. For close
snow removal, place skid shoes in the low position. Use
middle or high position when area to be cleared is
uneven. See Figure 8. When operating on gravel,
always put skid shoes in the high position.
Shoes _Hex Nuts
Figure 8
NOTE: Make certain the entire bottom surface of skid
shoe is against the ground to avoid uneven wear on the
skid shoes.