Table of Contents
Advertisement
• Place the hairpin clips in the inner holes in the weld pins and attach the starter rope as instructed in the Set-
Up Instructions.
THROTTLE
CONTROL
ADJUSTMENT
Clamp
Lever
On Engine I
Figure 8
If the throttle control requires adjustment or if it has been replaced, adjust the throttle control as follows.
• Remove the screw shown in Figure 8. Remove the cable clamp from the cable.
• Push the throttle control lever on the handle all the way forward as far as it will go, then back it off one
"click". Make certain the throttle control lever remains in this position.
• Push the control lever on the engine as far toward the rear of the engine as it will go. Secure the cable in
this position with the cable clamp and screw.
DRIVE CLUTCH
CONTROL
ADJUSTMENT
The drive clutch control adjustment wheel is located in the drive clutch control handle housing and is used to
tighten or loosen the drive belt, You will have to adjust the drive clutch control if any of the following happens:
, The mower does not propel itself with the drive clutch engaged.
* The mower's drive wheels hesitate with the drive clutch engaged.
To resolve the above problems, rotate the adjustment wheel with your fingers.
Clockwise to tighten the cable and
counter-clockwise
to loosen the cable. See Figure 9.
Models 370 - 379
\
\
\
\
\
\
\
\
\
Models 380 - 389
®
®
Figure 9
Note:
For some people the drive clutch handle may not be in a comfortable position.
You can adjust the handle
out by tightening the adjustment wheel.
13
Advertisement
Table of Contents
