Miele Novotronic G 842 PLUS Operating Instructions Manual page 18

Before using for the first time
Salt indicator
When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with reactiva-
tion sail
Start
Intake/Drain O
Salt P_/
Rinse aid O
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
started. The "Salt" indicator will be lit
during this process.
Bypassing the salt indicator
If your water is soft (below 8 gr/ga!) the
salt reservoir should not be filled with
salt. The indicator will remain lit and
should be disregarded or bypassed.
[] Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side, _.
[] Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
[] Using needle nose pliers, pull the
cap, _, off of the float chamber, and
remove the float, ,_@.
Replace the float chamber cap, push
the chamber back into its upright posi-
tion, and replace the salt reservoir cap.
The "Salt" indicator should no longer be
lit.
18