Product Specific Problems - Dell E2310HWFP User Manual

Image retention from a static Faint shadow from the static
image left on the monitor for a image displayed appears on
long period of time the screen

Product Specific Problems

Specific Symptoms
Screen image is too small Image is centered on screen,
but does not fill entire viewing
area
Cannot adjust the monitor with OSD does not appear on the
the buttons on the front panel screen
No Input Signal when user
No picture, the LED light is
controls are pressed
blue. When press "up", "down"
or "Menu" key, the message "
No input signal " will appear.
The picture does not fill the The picture cannot fill the
entire screen. height or width of the screen
Back to Contents Page
Settings OSD if the Color Management is turned off.
Change the Input Color Format to PC RGB or YPbPr in the Advance Setting OSD.
l
Run the built-in diagnostics.
l
Use the Power Management feature to turn off the monitor at all times when not in use
l
(for more information, see
Alternatively, use a dynamically changing screensaver.
l
In OSD Menu, under Reset to Factory Settings, select Enable LCD Conditioning. Using
l
this option may take several hours before the image is eliminated.
NOTE: Image Burn-in is not covered by your warranty.
l
What You Experience
Reset the monitor to Factory Settings.
l
Turn off the monitor, unplug the power cord, plug back, and then turn on the monitor.
l
Check the signal source. Ensure the Computer is not in the power saving mode by
l
moving the mouse or pressing any key on the keyboard.
Check whether the signal cable is plugged in properly. Re-plug the signal cable if
l
necessary.
Reset the computer or video player.
l
Due to different video formats (aspect ratio) of DVDs, the monitor may display in full
l
screen.
Run the built-in diagnostics.
l
Power Management Modes).
Possible Solutions