Maytag MDB3601AWW0 Use & Care Manual page 11

LIGHT WASH
Use this cycle for prerinsed or lightly-soiled loads.
Use both detergent dispenser sections.
Wash Rinse Rinse Main Rinse Final Dry Time Water
Wash Rinse (min) Usage
(gal/L)
• • • • • 85 5.7/21.8
RINSE ONLY
Use this cycle for rinsing dishes, glasses, and silverware that will
not be washed right away.
Do not use detergent with this cycle.
Wash Rinse Rinse Main Rinse Final Dry Time Water
Wash Rinse (min) Usage
(gal/L)
• • 20 2,9/10.9
You can cancel a cycle at any time.
1. Turn the cycle control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the cycle control knob to Off.
You can change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the cycle control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the cycle control knob can cause the covered
detergent dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4.
Close the door firmly until it latches. The dishwasher starts a
new cycle.
& ........ ...... ,
......
_,?_ ..............
2:}
You can add an item anytime before the main wash starts, or the
cycle control knob reaches Light Wash.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
anytime before drying begins.
No Heat Dry
Select this energy-saving option to dry without heat. No heat
drying is usdul when loads contain plastic dinnerware that may
be sensitive to high temperatures.
The dishes take longer to dry, and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.
NOTE: The dishwasher automatically heats the air in the
dishwasher during the "dry" portion of the cycle unless you
select No Heat Dry.
Heated Dry
Select this option to dry dishes with heated air. For best drying
results, use a liquid rinse aid and heated drying.
NOTE: Heated Dry is an option with all cycles except Rinse Only.
Temp Boost
Select this option to add extra heat to the water in the Normal
Wash or Light Wash cycles. This helps remove food soil.
Reset Options
Select this option to change an option setting. You can change
option settings anytime during a cycle as long as the cycle has
not passed the point where the option is used. For example, you
can press No Heat Dry anytime before the cycle control knob
reaches Dry.
1. Press RESET OPTIONS.
2. Press 1 or more options.
Delay Hours
Use Delay Hours to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start
1. Close the door.
2. Select a wash cycle and option(s).
3. Turn the cycle control knob clockwise to the number of hours
you want the dishwasher to delay the start.
NOTES:
• To cancel the delay, turn the cycle control knob to the desired
cycle.
• Rinse Only and Light Wash cycles cannot be delayed.
11