Maytag MSD2554ARW User Manual page 2

Important Safety Instructions ....................................
_)& WARNING _ When using your
appliance, always follow basic precau-
tions, including the following:
Use the refrigerator only for its intended purpose.
To prevent possibility of hazard due to electrical
shock, never plug the refrigerator into a receptacle
which has not been grounded adequately and in accor-
dance with the local and national electrical codes. See
the _k warning and grounding instructions.
Unplug the refrigerator before cleaning or replacing a
light bulb.
In case of power failure, minimize door openings. If
the power failure is of a long duration, protect the
food by placing blocks of dry ice on top of the pack-
ages or check with a local frozen foods locker about
temporary storage. Frozen foods which have thawed
completely should not be refrozen and should be dis-
carded.
• Any electrical service cord that becomes frayed or dam-
aged should be immediately repaired or replaced. Never
unplug your appliance by pulling on the power cord.
• "four refrigerator should not be operated in the pres-
ence of explosive fumes.
• Children should not climb, hang or stand on the
shelves of this refrigerator.
Important:
Child entrapment and suffocation are
not problems of the past. Junked or abandoned
refrigerators are still dangerous.., even if they will
sit for ".just a few days" If you are getting rid of
your old refrigerator,
please follow the
instructions below to
help prevent acci-
dents.
• Take off the doors.
• Leave the shelves
in place so that
children may not
easily climb inside.
WJ_#IlIING _ This appliance is designed
to operate on a normal 115 volt, 15 amp, 60
cycle line. There should be a separate,
grounded circuit serving this appliance only.
Do not use an extension cord. Do not use
any device that will alter the electrical per-
formance of this appliance.
This appliance is equipped with a three-pronged
grounding plug for your protection against possible
electrical shock hazards. It must be plugged into a
grounding receptacle. Where a standard two-prong wall
receptacle is encountered, it is the personal responsi-
bility and obligation of the customer to have it replaced
with a properly grounded three-prong wall receptacle.
Do not under any circumstances, cut or remove the third
(ground) prong from the power cord. Do not use an
adapter plug. Do not use an extension cord.
POWER SUPPLY CORD
WITH 3-PRONG
GROUNDING PLUG
t
(! Jl
\el
®
/I II
\ll
\
GROUNDING TYPE
WALL RECEPTACLE
Save These Instructions
• 1