Preparation For Use - Sears LXI 934.44709990 Owner's Manual

PREPARATION FOR USE
VHF/UHF COMBINED ANTENNA
VHF/UHF OUTDOOR ANTENNAS
The VHF/UHF Dipole Antenna (supplied) is
detachable. Insert the stem of the antenna into
the hole on the upper-back portion of the
TVNCR.
Connect the VHF/UHF Dipole Antenna or
VHF/UHF Combination Antenna to the Antenna
terminal of the "IVNCR as shown in the diagram
below.
For the best reception, fully extend the VHF/UHF
Dipole Antenna and make the necessary adjust-
ments. (Avoid touching the top section when
adjusting.)
VHF/UHF Antenna (Not supplied)
)ipole Antenna
(Supplied)
NOTE:
The connection of an indoor antenna may not
always give acceptable TV reception.
In some areas it will be necessary to use an
outdoor antenna. If you have separate UHF and
VHF antennas, you will need a VHF/UHF com-
biner (not supplied) to make the connection to
the Antenna terminal of the TVNCR.
If you have a VHF/UHF 75 ohm combination
antenna, you can make the connection to the
Antenna terminal of the TVNCR without
needing a VHF/UHF combiner.
VHF Antenna (Not supplied)
UHF
Antenna
pplied)
Flat twin-lead cable
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
If your cable system does not require a converter
box, simply connect the 75 ohm coaxial cable
(not supplied) from the cable system wall outlet
to the Antenna terminal of your TVNCR.
FromCable System
I 5-ohm Coaxial
Cable (Not
supplied)
ANT.
©
Note to CATV system installer:
This reminder is provided to call the CAI-V system installer'sattention to Article 820-40 of the NEC that
providesguidelinesfor proper groundingand, in particular,specifiesthat the cable ground shall be con-
nected to the groundingsystem of the building as close to the point of cable entry as practical.
- 11 - EN
8J14