Using Advanced Features - Sears 274.42418390 Series Owner's Manual

Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
lo
Place channels in
memory (autoprogram)
Cable/Air: Cable
Speakers: Off .
13
Speakers: Off
13
A. Hook up components before
you begin these steps or you
will not be able to add channels
into memory.
B. Press MENU repeatedly to
select the Setup Menu and
highlight Autoprogram.
C. Press + to start the TV adding
most of the channels into
memory.
D. Wait until the TV has cycled
through all the channels and
returns to the original channel.
2. Add or delete channels
3.
Press DONE to save the
setting
Controls Alarm Adjust Se_,
Autoprogram . '_+ _,_'_
Label 13 • • cleaF_
|I] IP.IIIII'..] I _II[=] el[o] I,I RI+'_J111] l=ll !
• CablelAir: Cable .:::+++_f+_
•Speak6rs: Off" :_
13
Controls Alarm Adjust Setup
Autoprogram .....
Label 13 clear
Cable/Air: Cable
,,_.+:,i.;+_i,!
Speakers: Off ......
A. Press MENU repeatedly to
select the Setup menu.
B. Press CHANNEL down to
highlight Channel Memory.
C. Select the channel number you
want to add or delete with the
number buttons.
D. Press + to add or delete a
channel (you will see Stored on
the screen to add and Erased to
delete).
E. Repeat C and D for more
channels.
12