Table of Contents
Advertisement
HOW TO INSTALL REFRIGERATOR
• Install Water Filter (Applicable to some models only)
• Before Installing water filter
1. Before installing the filter, take out the top shelf of the
refrigerator after tilting it to the direction (a) and lifting it
to the direction (b) and move it to the lower part.
2. Remove the lamp cover by pressing the protrusion
under the cover and pufiing the cover to the front.
• Installing water filter
1. Initial installation
of water filter
Remove the filter substitute cap by turning it
counterclockwise (a)
by 90 degrees and pulling it down.
Note : Keep it safe to use it later when you do not use the
filter.
Remove the red cap from the filter and attach the
sticker, Insert the upper part of the filter (a) after
aligning with the guideline marked on the control box,
and fasten it by turning it clockwise by 90 degrees.
Note : Check that the guideline and the fastening
indication
line are aligned.
_ubstitute
_=_=
Adhesion
_
_icker
2. Replacement
of water filter
While holding the lower part of the filter, turn it
counterclockwise (a)
by 90 degrees and pull it down.
Note : Check that the guideline and the loosening
indication line are aligned.
Control box
guide line
and the fastening
indication line
JI
O_i
;ontrolbox
"
"
" the guide line
and the loosening indication line
• After installing water filter
Reassemble
the lamp cover and the top shelf of the
refrigerator. To place the top sheff of the refrigerator,
raise
the front part of the shelf a bit so that the hook of the shelf
is fit into the groove.
In order to clean the water filter system, drain water for
about 3 min.
Note : Then open the door of the refrigerator
and check for
water droppings on the shelf under the filter.
-9-
Advertisement
Table of Contents
