Table of Contents
Advertisement
BEFORE
CALLING
FOR SERVICE
DON'T CALL FOR SERVICE
PROBLEM
POSSIBLE
CAUSE
UNTIL
YOU CHECK
• Oven light does not work
• Light switch In OFF position
• Check switch setting.
Light bulb burned out
• Check or replace light bulb; see
cleaning and care Instructions.
• Oven smokes
Broiler pen full of grease left
• Check pen and grid after each
In oven
use.
ADJUSTING
OVEN
TEMP
KNOB
The temperature
In your new oven has been set cor-
rectly at the factory, so be sure to fottow the recipe
temperatures and times the first few times you bake in
your new oven.
If you think the oven should be hotter or cooler, you can
adjust It yourself.
TO decide how much to change the
temperature,
set the oven temperature
25_F higher or
lower than the temperature
in your recipe, then bake.
The results of this "test" should give you an Idea of how
much the temperature should be changed.
To adjust
knob:
1. Turn OVEN CONTROL knob to OFF and remove the
knob by pulling straight off.
2. Look at the back of the knob. The arrow pointing to
the center of the bottom screw Indicates the original
factory setting.
3. Use a screwdriver to loosen the two screws about 2
turns each.
4. Hold the knob handle (A on Ulustratlon) while turning
the disk (B on illustration) in the desired direction to
Increase
or decrease
the
temperature
(See
Illustration below for "Standard
Thermostat).
As
you turn, you should be able to hear clicks and feel
notches or teeth. Each click or notch Is 15°F. You
can turn up to 2 clicks or notches In either dlrecUon.
5. When you reach the desired adjustment, retlghten
both screws.
"A"
"B"
KNOB
DISK
TO MAKE OVEN
COOLER
TURN DISK _
TO MAKE OVEN
14
NESER54
Advertisement
Table of Contents
