Pc Input Terminals Connection - Panasonic TH-42LF25U Operating Instructions Manual

Connections

PC Input Terminals connection

COMPUTER
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 30 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to "4:3", and 1,920 × 1,080 dots
when the aspect mode is set to "FULL". If the display resolution exceeds these maximums, it may not be possible to show
¿ ne detail with suf¿ cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need
to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Panasonic recommends using a PC cable that includes a Ferrite core.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci¿ ed
frequency range.
Signal Names for Mini D-sub 15P Connector
5 4 3 2
10 9 8 7
15 14 13 12 11
Pin Layout for PC Input
Terminal
12
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter
(if necessary)
Pin No.
1
1
6
2
3
4 NC (not connected)
GND (Ground)
5
Audio
Stereo mini plug (M3)
RGB
PC cable with
Ferrite core
Signal Name Pin No.
R
6
G 7
B 8
9
10
Shared with DVI-D IN.
Mini D-sub 15p
(Male)
Signal Name Pin No.
GND (Ground)
11
GND (Ground) 12
GND (Ground) 13
+5 V DC 14
GND (Ground)
15
(Female)
Signal Name
NC (not connected)
SDA
HD/SYNC
VD
SCL