Advertisement
is
Needle threader
Lower the sewing foot by means of lif
ting lever 16.
Turn the hand wheel until right looper
31 is positioned right of the needle
(see top of page 18). Place the thread
in slot A of needle threader 42 and
tauten it a little, holding the needle
threader a little turned to the front.
With the needle located between the
two guide lugs B move the needle
threader slowly downwards at the rear
side of the needle until small hook C
engages in the needle eye.
Hold the thread taut and place it in
hook D; it will then automatically be
placed in hook C, too.
Pull the needle threader to the rear, out
of the needle eye, and the thread will
be pulled through the eye.
Pull the thread completey through the
needle eye.
Thread spool change on threaded machine
Cut the threads close to the thread spool. Place new thread spools on spool holders 1 7.
Tie the threads still in the machine and the new threads to-gether. Pull the needle
threads out of the needles. Now pull at the thread ends until the knots are about 1 5 cm
past the last thread guide before the needles. Cut the knots off and pull the threads
through the respective needle eyes. The looper threads can be pulled until past the
looper eyes without interruption. Pull about 10 cm of thread through the looper eye.
11
Advertisement
