Advertisement
For cover stitch and two-thread chainstitch:
Remove blade guard (9) upward. Push the
power table, from the accessory box, from
above into the slot of the looper cover.
Screw the edge guide tight onto the power
table beforehand. Close looper cover.
Note: It is absolute necessary to disengage
the upper overedge looper, when attaching
the power table.
For cover stitch and two-thread chainstitch:
pFAF
The power table is marked with various
units of measurement. The figures on the
left are in mm, and those on the right are in
inches. These values show the distance to
the needle, when the stitch width is set at
3.5 mm. This is an aid to determine the
interval between the needle and the edge of
the fabric. Adjust the edge guide according
lv,
32
Advertisement
