Olympus E-PM2 Instruction Manual page 36

o
Sequential H
T
Sequential L
S
Y12s
2
Y2s
YC
$
Notes
• To cancel the activated self-timer, press the jY (G) button.
• In [S-AF] and [MF] focus modes, focus and exposure will be fi xed at the values for the fi rst
frame in each sequence.
#
Cautions
• During sequential shooting, if the battery check blinks due to low battery, the camera
stops shooting and starts saving the pictures you have taken on the card. The camera
may not save all of the pictures depending on how much battery power remains.
• Fix the camera securely on a tripod for self-timer shooting.
• If you stand in front of the camera to press the shutter button halfway when using the self-
timer, the photograph may be out of focus.
36 EN
Single-frame Shoots 1 frame at a time when the shutter button is pressed
shooting (normal shooting mode).
Photographs are taken at about 8 frames per second (fps)
while the shutter button is pressed all the way down.
Photographs are taken at about 3.5 frames per second (fps)
while the shutter button is pressed all the way down.
Press the shutter button halfway to focus, the rest of the way
Self-timer down to start the timer. First, the self-timer lamp lights up for
12 SEC approximately 10 seconds, then it blinks for approximately 2
seconds and the picture is taken.
Press the shutter button halfway to focus, the rest of the
Self-timer
way down to start the timer. The self-timer lamp blinks for
2 SEC
approximately 2 seconds, and then the picture is taken.
Set the number of frames to be shot. Select g, press the
Self-timer
Custom
INFO button, and rotate the dial.