Using The Tools - Hoover Widepath TurboPOWER Owner's Manual

Read "Before you begin cleaning"
instructions on page 9.
Be sure to check the cleaning code on
your upholstery. Use
your deep cleaner
only on upholstery marked "W" or
"W/S'.
1. Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
2. Fill clean solution tank with
HOOVER
Carpet/Upholstery Detergent according
to instructions for
Figs. 2a-8
to
2-14.
3. Attach tool to end of hose.
Do not point tools toward people or
pets.
4. Dry
hands and plug deep cleaner into
a properly grounded outlet.
5. Turn deep cleaner ON.
Ir
necessary,
refer to "Before using tool" section to
rerrlove air from the system.
.6. Gently press the tool onto the fabric.
Press
the trigger and slowly pull the noz-
zle over the fabric.
7. Overlap strokes by
1/2
inch to help
prevent streaking.
Make additional strokes without pressing
the trigger to remove more moisture.
8. To
clean in corners or creases, lift the
tool one-half inch from the fabric and
press the solution trigger.
The
crevice
tool (included in some models) is very
useful for this task.
9. Vacuum up the solution with the tool
without pressing the trigger.
A
\
\
B
10. For
heavily soiled areas, it may be
necessary to repeat the cleaning
process. Make crisscrossing strokes to
the original pattern; overlap each pass.
Make no more than 2 passes with the
solution over any one area to prevent
over-wetting and damage to fabric.
If additional Gleaning is necessary, wait
until the upholstery is completely dry
before using the tool again.
11. Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-oft", Fig.
2-6).
When finished cleaning, follow "After
Gleaning" instructions on page
9
and
"After using tool" instructions on page 12.
Removable brushes
Your deep Gleaner is equipped with
removable brushes for easy Gleaning.
To
remove brushes
Disconnect cleaner from electrical
outlet,
To prevent possible leaking, remove
clean solution tank and recovery tank.
Set tanks aside.
Press
handle release pedal to lower
handle.
Turn
cleaner over so bottom is
facing up.
Grasp inner portion of brush (A) and pull
brush assembly out slightly to reveal
latches (B).
B
Press both latches (B) and pull brush
block out.
The
brushes can be cleaned
under running watel.
To
replace
brushes
Align posts (C) on both ends of brush
assembly with slots
(D)
in cleaner hous-
ing.
Make sure that the square post (E) also
aligns with the square hole (F).
Turn
brushes slightly until post fits easily into
hole.
Press
brush firmly to snap into place.
13