Hoover Widepath TurboPOWER Owner's Manual page 11

How
to attach bare floor
attachment
(available at additional cost if not
included with your cleanerl
Disconnect deep cleaner from electri-
cal outlet.
To
prevent possible leaking, remove
clean solution tank (Fig. 2-8) and recov-
ery tank (Fig.
2-15)
before positioning
bare floor attachment.
Set tanks aside (do not set tank on furni-
ture).
1. With handle in upright position, tilt
cleaner back so that handle rests on the
floor.
2. With foam strip
(A)
(located under the
netting) in position as shown, place
attachment on front or nozzle (B).
Make sure arrow on end of attachment
points in the direction as shown.
3. Push
attachment against nozzle while
rotating attachment downward until both
ends snap into place.
(Note: Some force may be required to
rotate and snap attachment into place.)
4. Return deep cleaner to upright posi-
tion.
Lower
handle and replace recovery
tank.
5. Raise handle to upright position and
reposition clean solution tank.
To clean floor
Read "Before you begin cleaning"
instructions on page 9.
Do not use the deep cleaner on hard-
wood
floors.
I. Fill clean solution tank with
HOOVER
Bare Floor Cleaner _ according to
instructions for Figs. 2-8 to
2-14.
D0 not use any type of wax with your
deep cleaner.
2. Move speed selector to the L0 or HI
position for scrubbing or OFF if
scrubbing is not desired.
3. Dry hands and plug deep cleaner
into a properly grounded outlet.
4. Step on handle release pedal and
lower handle to operating position; turn
deep cleaner ON.
5. To release solution, press trigger.
Slowly move deep Gleaner forward and
backward over area to be cleaned.
6. To pick up dirty solution, release trig-
ger and slowly move deep cleaner over
area where solution has just been dis-
persed. Use both forward and reverse
strokes.
7. Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see
"Automatic shut-off",
Fig.2-6)
8. When finished Gleaning, follow "After
cleaning" instructions on pages
9-10.
Disconnect deep cleaner from electri-
cal outlet
and remove Pittachment from
nozzle. Rinse it in clear water. Do not
remove plastic screen or foam from
attachment.
_available at additional cost if not includ-
ed with your model
DH
\
Your model includes the following tools.
A. Powered hand t001
has
rotating
brushes for extra scrubbing action on
small carpet areas, carpeted stairs and
upholstery.
B. Stair/uph01stery nozzle has a built-in
brush to help provide the scrubbing
action some spots may need for
removal.
m
How to
attach tools
Disconnect deep cleaner from electri-
cal outlet.
1. Place handle in upright position and
remove hose from rack.
/5,11 tools attach to the hose in the same
rrlanner-:
2. Connect tool to hose by sliding it onto
connector until the tab (C) locks it
securely.
Using your thumb, push
forward and
up on the
latch (D)
to remove tool as
shown.
Before using tool
It
may be necessary to remove air from
the system ("prime the pump") so the
clean solution will flow to the tool.
Follow
these steps:
1.
Attach tool to hose and turn the deep
cleaner ON.
2. Put
the tool on a hard surface or
against your hand to block off the suc-
tion.
3. Wait a few seconds (can take up to 1 5
seconds). Then squeeze the trigger and
begin Gleaning.
Follow
the instructions on page
13
for
the appropriate cleaning task.
Continued -I) 11