Watching Tv; Channel Selection; Volume Adjustment - Emerson LC320EM8 Owner's Manual

TV
Select channels by pressing [CH A/'V] found on
remote control or on the TV's control panel, or by
pressing [the Number buttons] found on the remote
control.
'C;;_ ,' ,,_.... C_ _
@ @ @
@ @ @
e e
[CH A/T]
,, Use [CH A/T] to change the channel.
,, Same operation is also available with [CHAN-
NEL A/T] on the top panel of the main unit.
[the Number buttons]
,, Press the channel number with [the Number
buttons] to select a channel you want to watch,
then press [ENTER].
-When selecting analog channel 12
O-,O-,O
-When selecting digital channel 12-1
Be sure to press [-] before entering the minor
channel number.
,, If the channel broadcasts NTSC and ATSC both
and you don't press [-], you will receive the
NTSC channel only. The moment you press [-],
the lowest memorized digital channel will be dis-
played.
,, Press [CH RETURN] to return to the previously
viewed channel.
NOTE:
. tn DTV broadcasting, one cbannel sometimes broadcasts
multiple programs depending on the air time. tn this case,
the main channel is called major channel and the minor
channel is called mll_or channel
About minor channel broadcasting:
There may be different programs being broad-
cast on minor channels through a single chan-
nel from ATSC. You can watch each minor
channel program being broadcast by selecting
one of the minor channels.
NTSC ATSC
18:00
18:30
19:00
19:30
20:00
: change automatically
=> : change manually by pressing [CHA/v]
on your remote control
NOTE:
, "No Signal" will appear on the screen after the minor
channel broadcast is oveg
You will need to change the channel to continue
watching another TV program.
This section describes how to adjust the volume.
The mute function, which turns the sound off and
on, will also be described.
[VOL. A/_]
,, Use [VOL z_7] to adjust the audio volume.
,, The same operation is available with [VOLUME
AP] on the top panel of the main unit.
,, The volume bar will be displayed at the bottom
of the screen when adjusting the volume.
,, The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
,, Press [MUTE] to turn off and on the sound.
,, "Mute" is displayed on the screen for a few sec-
onds.
,, Press [MUTE] again or [VOL A..'V] ([VOLUME
AFT]) to release the Mute status.
EN