Materials Needed; Basic Tools; Additional Tools N Eeded W Hen Sweat Soldering - Kenmore 153.313340 Owner's Manual

Materials Needed
To simplify the installation Sears has available the installation
parts shown below, You may or may not need all of these
materials, depending on your type of installation,
WATER HEATER
INSTALLATION
KIT WITH FLEXIBLE
CONNECTORS
FOR 3/4" OR
1/2" THREADED OR
COPPER PLUMBING
EXPANSION TANKS FOR THERMAL EXPANSION
CONDITIONS AVAILABLE iN 2 GALLONS
(7.6 LITERS) AND 5 GALLONS (18,9 LITERS)
CAPACITY THROUGH LOCAL SEARS STORE OR
SERVICE CENTER
DRAIN PANS AVAILABLE IN 20" (508 ram)
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18" (457 ram) OR
LESS, 24" (610ram) DIAMETER FOR
WATER HEATERS HAVING A DIAMETER
22" (559 ram) OR LESS AND AVAILABLE
IN 28" (711 ram) DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 25"
(560 ram) OR LESS
Basic Too_s
You may or may not need al! of these tools, depending on your
type of installation, These tools can be purchased at your local
Sears store,
Pipe Wrench (2) 14"
Screwdriver
6 Foot Tape or Folding Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
DRILL
SLOT-HEAD SCREWDRIVER
ROLL OF TEFLON TAPE (USE ON
WATER CONNECTIONS)
PHILLIPS SCREWDRIVER
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER CONNECTIONS
GARDEN HOSE 5 FOOT TAPE PIPE WRENCH
Additiona_ Too_s Needed
When Sweat Soldering
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
TUBING CUTTER
PROPANE
TORCH
ROLL OF
EMERYCLOTH
HACKSAW
ROLL OF
LEAD-FREE
SOFT SOLDER
3/4" (19 mr#) WiRE BRUSH
1/2" (15 ram) WIRE BRUSH
SOLDER
FLUX