Advertisement
Grill
Lighting
Instructions
1. Before
each
use, check
all hoses for cracks,
nicks,
cuts,
burns
or abrasions.
If a hose is damaged
in any way,
do
not use your
grill before
replacing
the hose with
an
authorized
part from the Parts
List. Also
make
sure all
gas supply
connections
are securely
tightened.
2. Familiarize
yourself
with the safety
and Use and Care
instructions
in this manual.
Do not smoke
while
lighting
grill or checking
gas supply
connections.
3. Be sure the LP Gas tank
is filled or the Natural
Gas Line
is attached
to the gas source.
4.
Open
the Grill Lid.
5. Check
that the end of each
Burner
Tube
is properly
located
over each
Valve
Orifice.
Failure
to replace
a faulty
hose,
secure
gas
supply
connections
or to open
the
Lid
before
proceeding
to the
Lighting
Procedures
could
result
in a fire
or explosion
that
could
cause
serious
bodily
injury,
death,
or property
damage.
6. Set Control
Knobs
to OFF and open
the LP Gas
tank
valve
SLOWLY
1/4 of a turn.
For Natural
Gas
open
the Shut Off Valve at source.
I
Open
LP
Gas tank
OFF
Side
Burner
Lighting
Instructions
1. Follow steps 1 through 5 of the Grill Lighting
instructions.
2.
3.
4.
5.
6.
Open
Side
Burner
Lid.
Set Control
Knobs
to OFF and open
the LP Gas
tank
valve
SLOWLY
1/4 of a turn.
For Natural
Gas
open
the Shut Off Valve
at source.
Push and turn the Control
Knob
to HIGH.
The built-in
spark
ignitor
will light the Burner
automatically.
You may have to push
and turn the Control
Knob
up
to 3 or 4 times to light.
If ignition
does
not occur,
turn
the burner
Control
Knob
and gas source
OFF and conduct
a leak test of
ALL
gas connections
and fuel
sources.
If no leaks
are detected,
wait 5 minutes
for any gas to clear and
repeat
the lighting
procedure.
Manually Lighting Your Grill By Paper Match
To light your gas grill by match,
insert
a match
into the
Lighting
Stick and follow
steps
1 through
6 of the Grill
Lighting
instructions.
Then,
light the match
and place
Lighting
Stick through
the Lighting
Hole on the left side
of the grill as shown
below.
Turn
the nearest
Control
Knob
to the HIGH
setting
to release
gas.
The Burner
should
light
immediately.
7. Push and turn the LEFT
Control
Knob
to HIGH.
HIGH
/
/
OFF
_
i
Lighting
Hole
8. immediately
press
the
Electric
ignitor
for
3-4
seconds
to light
the
Burner.
PRESS
9. If ignition
does
not occur
in 5 seconds,
turn the burner
Control
Knob(s)
and gas source
OFF and conduct
a
leak test of ALL
gas connections
and gas sources
as
explained
in the Use and Care section
of this manual.
If no leaks
are detected,
wait 5 minutes
for any gas to
clear
and repeat
the lighting
procedure.
10. After one Burner
is lit, turn the tank valve SLOWLY
one
more
1/4 of a turn for 1/2 of one complete
turn.
1 1. Once one Burner
is lit, the adjacent
Burner
can be lit by
turning
its Control
Knob
to HIGH.
Lighting
Stick
Match
Never
lean
over
the grill
cooking
area
while
lighting
your
gas
grill.
Keep
your
face
and
body
a safe
distance
(at
least
18 inches)
from
the
Lighting
Hole
or Burners
when
lighting
your
grill
by match.
19
Advertisement
