Advertisement
SECTION 3: KNOW YOUR TILLER
Clutch Control
Handle Adjustment Lever
--....
Figure 4
WARNING:
Read,
understand,
and
follow all instructions
and warnings
on
the machine
and in this manual
before
operating,
TineClutchControl
The clutch control lever is located on the left handle.
Squeezing the lever against the handle engages the
tine drive. Release the lever to stop the tines from
turning. See Figure 4
DepthStake
The depth stake is located in the rear of the tiller and it
controls the tilling depth. See Figure 4
HandleAdjustment L ever
The handle may be adjusted to the height desired.
Loosen the handle adjustment lever a few turns and
pivot handle up or down to desired position. Tighten
lock. See Figure 4.
ThrottleControl
The throttle control lever is located on the engine. It
controls the engine's speed and stops the engine.
With the throttle control pushed completely forward,
the carburetor is in START or FAST position. Use
maximum engine speed for deep tilling.
Pull the throttle control back to reduce engine
speed to IDLE. Throttle control should be at IDLE
for transporting the tiller.
Pull the throttle completely back to stop the engine.
ChokeLever
The choke lever is located near the throttle control. It is
used to enrich the fuel mixture when starting a cold
engine.
StarterHandle
The starter handle is located on the engine and is
used to manually start the engine.
EngineControls
See the separate engine manual for additional
information and functions of the engine controls.
Advertisement
