Table of Contents
Advertisement
Automatic Ice and
Water Dispenser
(continued)
Order
new filter
cartridges
through
the
dealer
where
you
bought
the
refrigerator,
or contact
the
Frigidaire
Consumer
Assistance
Center
at 1-800-
944-9044.
It might
be good
to order
some
filters
when
you
first
install
your
refrigerator.
Be sure to ask for the RC-
200
PureSource
Plus
TM
replacement
cartridge.
The
PureSource
Plus
TM
RF-200
ice and
water
filter
system is tested
and certified
by
NSF
International,
the
nationally
recognized
and respected,
not for profit,
certification
organization
for
public
health
safety.
The
PureSource
Plus
TM
system
is tested
and
certified
to ANSI/
NSF
Standards
42
and
53.
See
performance
data
sheet
for
specific
claims.
This system
should
not be used on
water
that
is microbiologically
unsafe
or
with
water
of unknown
quality
unless
the
water
has
been
adequately
disinfected
before
or
after
traveling
through
the filtration
system.
Rated
service
flow-
.37 GPM
Maximum
Rated
Pressure-
125 PSI
Maximum
Operating
Temp.
- 100 °
Changing the Filter:
Water quality varies throughout the world. To ensure the highest possible water
quality, change water filter every 6 months, or 200 gallons. Also, if filter has been
in a refrigerator that has not been in use for awhile (during moving for example),
change filter before reinstalling refrigerator. Note dispenser system will also operate
without filtration (with filter cartridge removed).
To change filter:
Refer to Figure 1 asneeded. It isnot necessary to turn the water supply off to change
the filter.
1. Set ice maker lever (wire signal arm) to the OFF (up) position.
2. Hold filter cup firmly, and unscrew counter clockwise (Figure 1). (Some water
could leak out asyou remove cup. This is normal.) Filter cartridge should come
down with cup. If cartridge remains in housing, pull down gently, while twisting
filter back and forth.
3. Empty cup of any substance.
4. The large o-ring (Figure 1) that seals the filter system sets in the o-ring groove
down inside the cup. Should the o-ring fall out during filter cartridge replacement,
simply place it back in the groove prior to screwing the cup back in place. If the
o-ring becomes damaged, you will need to order a new one from the Consumer
Assistance Center.
5. Discard old filter cartridge.
6. Remove new filter cartridge from packaging, and install.
7. Place filter cartridge in cup. The end with the small o-ring should be up, out
of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall
Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely
tightened with Pure$ource Plus TM Logo facing outward. Do Not Tighten Past
Stop.
9. Set ice maker level on the ON (down) position.
10.Check for leaks. Open refrigerator door. Wipe any water drops from the filter cup.
Run a glass of water. If there is a leak, unscrew filter cup, and reinsert the filter
cartridge. Check placement of large O-ring (see Figure1). Reinstall filter cup,
making certain it is tightened completely.
11 .To condition filter system and purge air from water line, run several glasses of
water through water dispenser. This will also assure that the purest water
possible is stored in water tank.
IMPORTANT
After replacing the filter cartridge, it will be necessary to reset the filter use up
indicator that islocated on the iceand water dispenser. Pressthe "Change Water
Filter" pad. If the indicator light was red or amber, you will need to press the pad
for 3-5 seconds to reset. If the light isstill green you will need to pressthe pad for
10-12 seconds to reset. The light will flash on and off when reset is complete.
Pleaserefer to the complete dispenser operating instructions attached to the
inside of the freezer door.
Figure 1
10
Small O-tin
Cartridge
Large O-r eg_
Filter Cu pd_'_i
i
TWIST TO REMOVE
Advertisement
Table of Contents
