Frigidaire FGES3045KFE Use & Care Manual page 35

SETTING KEEP WARH DRAWER CONTROL (If equipped)
Keep warm drawer rack positions
The rack can be used in 2 ways:
• Zn the upright position (Figure I) to allow low
profile food items to be placed both under and on top
of the rack (for example, rolls or biscuits on top of
the rack and a casserole dish underneath).
• In the downward position (Figure 2) to allow you
to place light weight food items and empty dishware
(for example, rolls or pastries and dinner plates) on
the rack.
Set the keep warm drawer rack in either position.
"I]jFJFigure 1 Figure 2
Operating the keep warm drawer
The purpose of the keep warm drawer is to keep hot
cooked foods at serving temperature. Always start with
hot food. It is not recommended to heat cold food in
the keep warm drawer. All food placed in the keep warm
drawer should be covered with a lid or aluminum foil to
maintain quality. Do not use plastic wrap to cover food.
Plastic may melt onto the drawer and be very difficult to
clean. Use only utensils and cookware recommended for
oven use in the keep warm drawer.
Always use potholders or oven mitts when
removing food from the keep warm drawer as cookware
and plates will be hot and you can be burned.
To set the keep warm drawer controls
The control and indicator lights for the keep warm
drawer features are located on the control panel. The
temperatures are approximate, and are designated by HI
(high), HED (medium) and LO (low).
I. Touch the enooff pad (see Figure 6) at the keep
warm drawer control position. The keep Warm drawer
indicator light will flash. Note: If no further pads are
touched within 25 seconds the request to power the
keep warm drawer ON will clear.
2. Set the desired power level. Touch A once to turn ON
the power level for HI (see Figure 3) or v to turn ON
the power level for LO (see Figure 5). The keep warm
drawer indicator light located beside the onoeff pad
will turn ON steady,
3. Each touch of the v or A pads will decrease or
increase through 5 power levels from HI (see Figure
3) to lED (see Figure 4) to LO (see Figure 5).
4_
Note: For best results, preheat the keep warm drawer
before adding the food. An empty drawer will preheat
in approximately 15 minutes.
When the food is ready for removal,
touch the enooff pad once to turn
the keep warm drawer OFE The
keep warm drawer indicator light will I
turn OFF:.
1 w reed
I
I hi D hi D hi E
low
[] f-I E]
(
[] reed I reed [] reed [
I
[] m D E
[] low m low I low Q on.off
keep worm
drawer
E hi
Figure 3 Figure 4 Figure 5 Figure 6
NOTE
The keep warm drawer is inoperable during the self-
clean cycle.
The keep warm drawer is equipped with a latch which
may require extra force when opening and closing the
drawer.
Keep warm drawer temperature selection
Recommended keep warm drawer settings table is shown
below. If a particular food is not listed, start with the
MED setting. I1: more crispness is desired, remove the lid
or aluminum foil from the food. Host foods can be kept
at serving temperatures on the PIED setting. When a
combination of foods are to be kept warm (for instance,
meat with 2 vegetables and rolls), use the HI: setting. To
avoid heat loss, do not open the keep warm drawer while
in use.
Keepwarm drawer recommendedfood settingstable
Food Item Setting
Bacon, Hamburger Patties Hi
Poultry, Pork Chops H[
Fried Foods, Pizza HI
Gravies, Casseroles NED
Vegetables, Eggs !'4ED
Roasts (Beef, Pork, Lamb) NED
Biscuits, Pastries NED
Rolls, hard NED
Rolls (soft) LO
Empty Dinner Plates LO
35