Basic Connection - JVC XV-N322S Instructions Manual

Before making connections:
• Do not connect the AC power cord until all other connections have been made.
• Connect VIDEO OUT of the player directly to the video input of your TV. Connecting VIDEO OUT of the
player to a TV via a VCR/an integrated TV/Video system may cause a monitor problem.
BasicConnection
Audio/video
cable*
(supplied)
S-video cable* TV
(not supplied)
The player
White
NOTES
• If your TV has a monaural audio input
instead of stereo, use an optional audio
cable which converts stereo audio output to
monaural.
• If your TV is a HDTV or HD-ready TV, you can
connect with component (Y, PB, PR) jacks. By
connecting with component (Y, PB, PR) jacks,
you can select the progressive scanning
mode which provides the best picture quality.
* The S-VIDEO jack and component (Y, PB,
PR) jacks cannot be used at the same time.
When using the S-VIDEO jack, do not
connect the component (Y, PB, PR) jacks
with the player.
Red
Connecting to a TV with component jacks
Connecting to a stereo audio amplifier (receiver)
To component video input
To switch the scanning mode between Progressive and
Interlace, press and hold VFP-I/P on the remote control
for a few seconds.
NOTES
• Connect "Y" to "Y,""PB" to "PB(CB),""PR" to "PR(CR)"
correctly.
• When using component (Y, PB, PR) jacks, do not
connect S-VIDEO jack with the player.
About the scanning mode indicator
[PICTURE SOURCE] of
the PICTURE menu
AUTO
FILM
VIDEO[NORMAL]/
[ACTIVE]
NOTE
Source type of DVD VIDEO
Film source Video source
[DDP] [P]
[DDP] [DDP]
[P] [P]
Some progressive TV and High-Definition TV sets are
not fully compatible with the player. To check the
compatibility of your TV, contact your local JVC
customer service center.
I
To analog audio input
Connecting to a digital audio device
To enjoy high-quality surround sound, connect the
DIGITAL OUT (COAXIAL) jack to a Dolby Digital or DTS
decoder or an amplifier with a built-in decoder.
To analog _ audio input
i I I
To digital audio input _
NOTES
• Depending on tile disc, no signal may be outputted
from the DIGITAL OUT. Make an analog connection
in this case.
• Set [DIGITAL AUDIO OUTPUT] in the [AUDIO]
preference display correctly according to the
connected digital audio equipment. (See "DIGITAL
AUDIO OUTPUT" in "Initial settings.")