Frigidaire CRA086HT10 Use & Care Manual page 7

DO THIS:
PRESS FILTER
RESET BUTTON
YOU WILL SEE:
tamp/timer
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will
illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off.
REMOTE SENSING FEATURE
(on some models):
o
TEMP/TfMEI{
[2 © ©
5 © 0
..... _,_ _'o/_
FRIGIDAIRE
DO THIS:
I PRESS REMOTE
SENSING
START BUTTON
LIGHT pulsing ( On & Off intermittently ).
lamp/timer
remqte
sensing
NOTE: Unit
display
shows the set temperature
NOTE: Remote display
is actual temperature
at remote control only
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use
the" A V "buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself ). The LIGHT on the unit control wilt pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it
sends a signal. It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button, tf the unit
does not receive the remote sensing signal during any 3 minute interval, the unit wilt beep to indicate the remote sensing mode has
ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit.
HEATING FEATURE(on some models):
tamp/rimer
auto
[] hi
mad
lo
heat
[] cool
energy saver
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
YOU WILL SEE:
tamp/rimer
adto
[] hi
mad
lo
[] heat
cool
energy saver
/anonly
Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models), Timer, or Sleep Modes. When in
the "Heat" mode,the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between
13 °C(55 °F) and 27 °C(80 °F). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room
air.
@2009 Electrolux Home Products, Inc. All rights reserved.
/