Frigidaire CRA086HT10 Use & Care Manual page 5

Operating Instructions
TO CHANGE TEMPERATURE SETTING: YOU WILL SEE:
temp/timer
m hi
mad
lo
heat
[] cool
energy saver
#n onk
__[.... DO THIS:
_L____ PRESS A TO RAISE
_ PRESSV TO LOWER
auto
[] hi
med
lo
heat
[] cool
energy saver
fanonly
temp/timer
Note: Tap or hold either up ( A ) or down ( V ) button until the desired temperature is seen on the display. This temperature will
be automatically maintained anywhere between 16 °C (60 °F) and 32 °C (90 °F) for cooling mode. The temperature will be auto-
matically maintained anywhere between 13 °C (55 °F) and 27 °C (80 °F) for heating mode. If you want the display to read the
actual room temperature. See "To Operate on Fan Only" section on this page.
TO AD3UST FAN SPEEDS: YOU WILL SEE:
temp/timer
auto
[] hi
r,,ed I_)
_n only
_._ DO THIS:
PRESS TO SELECT
auto
hi
med
mlo
heat
[] cool
energy saver
fan only
temp/_mer
TO USE AUTO FAN FEATURE: YOU WILL SEE:
Letup/timer
auto
hi
med
•lo
re•p/timer
[] cool
energy saver
fanomy
DO THIS:
PRESS FAN
BUTTON
SELECT AUTO
[] auto
hi
med
lo
heat
[] cool
energy saver
/a_only
%
Note: Fan starts at High Speed and adjusts to a slower speed as the room temperature dictates. For example, if the room doesn't
get too warm, it will stay at the slowest speed. If the room temperature rises quickly, such as a door being opened, it will auto-
matically go to the highest speed. The fan speeds will re-adjust back to the slowest speed as the room returns to the original set
temperature. Press either the fan slower or fan faster button to adjust the fan speed manually. This function is deactivated in the
heating mode on 115V models.
TO OPERATE ON FAN ONLY: YOU WILL SEE:
re•p/timer
[] auto
hi
med
heat
[] cool
energy saver
Note: Use this function onl'
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
auto
[] hi
med
lo
heat
cool
energy saver
m fan on_
ternp/timer
when cooling is not desired, such as for room air circulation or to exhaust stale air on some models.
(Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can
choose any fan speed you prefer. (Except "Auto Fan").
During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. Fan Only
cannot be selected when the unit is in the "Remote Sensing" mode. (on those units with that feature).
02009 Electrolux Home Products, Inc. All rights reserved.
r-