Frigidaire CRA083AT71 Use & Care Manual page 7

Operating Instructions
(continued)
TIMER: DELAY STOP J START FEATURE
c[earl _ [] cool
remote
\
econ sensing
air Ian only
ternp/timer
|
Hr
\ \/
FIRST THEN
DO THIS:
DO THIS;
PRESS
TIMER BUTTON
PRESS
UP/DOWN BUTTONS
YOU WILL SEE HOW MUCH TIME IS CHOSEN:
dean i " cool
econ
air fanonly
[]
timer MODE
remote
sensing
temp/timer
v ON-OFF A
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( V ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected). The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
CHECK FILTER FEATURE, YOU WILL SEE:
remote
sensing
temp/timer
euto [] I []
medhi
/ filter
Zo reset
V ON-OFF A FAN SPEED sleep
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
CLEAN AIR FEATURE(on some models):
temp/timer
outo []
remote _ hi
filter
sensing C _ med
Zo reset
-- 2
V ON-OFF A FAN SPEE_
/
DOTHIS: /I
PRESS FILTER
RESET BUTTON
f temp/timer
dean
I [] cool remote _
. \ econ sensing _ C
alr_\ L_ _en only
_MODE 0N-0FF A
v
X Do THIs:
PRESS
CLEAN AIR
BUTTON
" L
dean [] cool remote
air SeCOnonlysensing
temp/tirner
timer MODE V 0N-0FF A
@2009 Electrolux Home Products, Inc.
m
Note: When this feature is "ON", the electronic air purifier is
energized to remove pollen and impurities from the air. To
cancel this feature, press the Clean Air button (the LIGHT
will turn off).
Note: This feature can be activated on the unit touch pad
ONLY.
All rights reserved.
7