Table of Contents
Advertisement
Available languages
Available languages
NOTE: Proper installation isyour r esponsibility.
Make sure youhave everything necessary forcorrect installation, Itisthepersonal
responsibility
andobligation ofthecustomer tocontact aqualified i nstaller toassure t hatelectrical installation meets a llnational and
• Level
• Tape measure
• Pliers
• Scissors
IMPORTANT:
local c odes a ndordinances.
Tools needed:
Gather therequired tools andparts before s tarting i nstallation.
• Phillips n o.2screwdriver
• Flat-head screwdriver
• ¾6" B ox-end wrench
• Utility knife
Donotgrasp control panel tomove compactor.
Toavoid damaging floorcovering, slide compactor onto
cardboard orhardboard before m oving c ompactor across
floor.
Donotallow therear f rame o fthecompactor totouch the
floorcovering when lifting ormoving c ompactor.
Undercounter
Installation
Measure the height of your cabinet opening. The top of the
compactor
should be at least 1/8" (3 mm) from the top of the
cabinet opening.
The rear wheels are preset for a cabinet opening of 34Y4"
(87 cm). See Position "1" in picture following.
To adjust for other cabinet opening heights:
•
Loosen self-tapping
screw just enough to clear stud from
hole in Position "1 ."
•
Move the rear wheel and stud to Position "2" or "3" as
needed for your cabinet opening measurement:
Position "2": 34%" to 347/16 '' (87 to 87.5 cm)
Position "3": 347/_6 '' to 34%" (87.5 to 88 cm)
NOTE: To level the compactor
in position "3," you may
need to add shims under the leveling legs.
•
Tighten screw. Repeat for other rear wheel.
2. Use pliers to lower leveling legs away from cabinet. Adjust
legs so there will be a W' (3 mm) to %" (6.4 mm) space
between the top of the compactor
and the top of the cabinet
opening. Stand the compactor
upright.
3. Move the compactor
close to its final location.
4. Plug into a grounded 3 prong outlet.
5. Determine if you want the compactor
frame or drawer front
flush with the cabinet front.
Using the two #8-18 x %6" (8 mm) screws, install the retaining
brackets to cabinet top as needed:
If the compactor frame is to be flush with the cabinet
front, place retaining bracket screws through "1 ."
If the compactor
drawer front is to be flush with the
cabinet front, place retaining bracket screws through "3."
If the compactor
is to be midway between "1" and "3,"
place the retaining bracket screws through "2."
"",,..
A. Countertop
B. Retaining bracket
6.
Slowly lift the front slightly and roll compactor into the cabinet
opening.
Using the two #8-18 x _/2"(12 mm) screws, fasten the
retaining brackets to the countertop with the mounting
screws.
Countertop
Mounting
A. Wheel bracket assembly
B. Cabinet
C. Locating stud
D. Self-tapping
screw (pivot)
A. Countertop
B. Retaining bracket
C. Mounting screw
If brackets cannot be attached to the underside of
countertop,
attach mounting clips to brackets. Fasten
compactor
to cabinet front with mounting screws through
mounting clips.
Advertisement
Table of Contents
