Installation Instructions; Unpacking - Jenn-Air TC707 Use & Care Manual

Hide thumbs Also See for TC707:
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT SAFETY INSTRUCTIONS
WARNING:when
using an electrical
appliance,
basic precautions
should always be followed,
including
the following:
• Read all instructions
before using the compactor.
• Close supervision
is necessary when used by or near
children. Do not allow to be used as a toy, or to run
unattended at any time. Lock Key Switch when not in use
and store key out of reach of children.
• Do not touch moving parts.
• Do not operate with a damaged cord set, plug, motor, or
after damage in any manner. Have the compactor
examined, repaired or adjusted by an authorized
serviceperson.
• Use only for intended use as described in this manual. Do
not use other than manufacturer's
recommended
attachments.
[] Do not compact toxic or volatile flammable material such as
oily rags and insect sprays. Do not compact
lighted
cigarettes, cigars, or other hot or burning items. Do not
overload the compactor.
[] Do not take apart the compactor.
Incorrect reassembly can
cause electric shock when subsequently
used.
[] Handle a loaded trash bag with care. Sharp objects can
pierce the bag and cause injury. Do not overload trash bag
with heavy material such as glass.
[] This compactor
is intended for household use only.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Installer:
Leave Use and Care Guide with the homeowner.
Homeowner:
Keep Use and Care Guide for future reference and for local electrical inspector's
use, if required.
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT:
Do not grasp console to move compactor.
Begin in the room where the compactor will be located.
1. Remove compactor
from shipping carton. Remove all
protective packaging materials such as tape and shipping
pads. Use a mild detergent and warm water to remove waxy
residue caused by protective shipping material. Dry
thoroughly with a soft cloth. For more information, see
"Cleaning."
2. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
A. Cord clip
3.
4.
Place the 2 corner posts from the carton on the floor near the
compactor.
Open the compactor
drawer and remove any
shipping materials or other items from the drawer. Do not
remove the compactor
bag. Grasp the handle and raise the
front of drawer until it clears the drawer stops. Grasp sides of
drawer and lift drawer out of compactor.
Place the drawer on
the 2 corner posts.
Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor
cabinet and put
compactor
on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.
A. Leveling legs
B. Shipping base

Advertisement

Table of Contents
loading

Table of Contents