Jenn-Air JFC2089HPR Use & Care Manual page 7

I NSTALLATI 0 N
Door Reinstallation
Materials Needed:
• Phillips screwdriver
• 5/,6" hex head driver
1. Install hinge assemblies:
• Install center hinge with Phillips screws.
2. Place hinge side of refrigerator door
on center hinge pin.
• Install top hinge with 5/,;, hex head
sc rews.
3. While holding refrigerator door
upright, tighten down top hinge
with _/,_"hex head driver. "--.
4. Reconnect two-pin connector.
5. Replace top hinge covers.
Handles
(style varies by model)
This handle style is installed at the factory. Style may
vary by model.
Materials Needed:
• 3/32" A llen wrench
To Remove:
• Remove set screw from
handle mounting post
using the %;' Allen
wrench.
• Repeat the procedure on
all posts to remove the
handle.
To Remove:
• Loosen set screws in handle using 3/3;'Allen
wrench.
• Repeat the procedure on all screws.
To Replace:
• Align handle with the mounting posts.
• Apply upward pressure to the handle and hold.
• Fully tighten all set screws to secure handle in
place.
Opening and Closing Your
Fresh Food Doors
Your new refrigerator is uniquely designed with two
fresh food doors. Either door can be opened or closed
independently of one another.
There is a vertically-hinged section on the left fresh
food door. When the left door is closed, the hinged
section automatically forms a seal between the two
doors when both doors are closed.
When the left door is opened, the hinged seal
automatically folds inward so that it is out of the way.
To replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.
Metal Handle
Materials Needed:
• 3/3;'Allen wrench
• Gloves to protect hands
I Note:
Metal handles scratch doors.
can
I