Inglis IJU25262 Use & Care Manual page 23

4. Placea shallow panunder thewater
supply valve.Then,usea wrench to
disconnect thewaterinletfromthewater
supply valve.Separate t hewaterinlet
fromthewatersupply valveanddrain
waterintothepan.
5. Remove the spring clamp from the water
outlet and separate from the water
supply valve; drain water into pan.
6. Reconnect both water inlet and water
outlet to the water supply valve.
7. Empty the pan and reposition it under
the water pump.
8. Remove the clamp and disconnect the
drain hose from the water pump; drain
water into pan.
9. Reconnect drain hose to the water
pump, being sure to position the clamp
over the connection.
10. Replace the lower access panel.
NOTE: If your dishwasher is connected to
a garbage disposal, do not run water into
the sink after winterizing. This could cause
water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower
access panel and remove lower
access panel.
2. Turn on the water supply to dishwasher.
3. Reconnect power or plug in dishwasher.
4. Run dishwasher through a complete
cycle and check for leaks.
5. Replace lower access panel.
Storing for the summer
Protect your dishwasher during the summer
months by turning off the water supply and
power supply to the dishwasher.
Built-in models
l Water outlet
Spring Water pump
clamp and motor
%,,¸¸¸
%
Water supply Water Drain
valve inlet hose
Portable models
Spring Screw Water pump
Water outlet clamp clamp and motor
O!
Water supply Water Drain hose
valve inlet
23