Advertisement
OPERATION
The operation of any tractor can result in foreign objects thrown into the eyes, which can result
in severe eye damage.
Always wear safety glasses
or eye shields while operating your tractor
or performing any adjustments or repairs.
We recommend standard safety glasses or a wide
vision safety mask worn over spectacles.
HOW TO USE YOUR TRACTOR
•
Turn ignition key to "STOP" position and remove key.
Always remove key when leaving tractor to prevent
unauthorized use.
TO SET PARKING
BRAKE(See
Fig. 4)
Your tractor is equipped with an operator presence sens-
ing switch.
When engine is running, any attempt by the
operator to leave the seat without first setting the parking
brake will shut off the engine.
Depress brake pedal (B) all the way down and hold.
Pull parking brake lever (C) up and hold, release pres-
sure from brake pedal (B), then release parking brake
lever. Pedal should remain in brake position.
Make
sure parking brake will hold tractor secure.
Never
use the choke to stop engine.
IMPORTANT:
LEAVING THE IGNITION
SWITCH
IN ANY
POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY
TO BE DISCHARGED,
(DEAD).
NOTE:
Under certain conditions when tractor is standing
idle with the engine running, hot engine exhaust gases may
cause "browning" of grass. To eliminate this possibility, al-
ways stop engine when stopping tractor on grass areas.
CAUTION:
Always
stop tractor
com-
pletely, as described above, before leav=
ing the operator's
position; to empty
grass catcher, etc.
TO USE THROTTLE
CONTROL
= D (See Fig. 6)
Always operate engine at full speed (fast).
•
Operating engine at less than full speed (fast) reduces
engines operating efficiency.
•
Full speed (fast) offers the best bagging and mower
performance.
FIG. 4
STOPPING
(See Fig. 5)
MOWER BLADES -
To stop mower blades,move attachment clutch lever
to "DISENGAGED"
position.
FIG. 5
GROUND DRIVE -
•
To stop ground drive, depress brake pedal into full
"BRAKE" position.
IMPORTANT:
FORWARD
AND
REVERSE
DRIVE
PEDALS RETURN TO NEUTRAL POSITION WHEN NOT
DEPRESSED.
ENGINE -
•
Move throttle control between half and full speed (fast)
position.
NOTE:
Failure to move throttle control between half and
full speed (fast) position, before stopping may cause engine
to "backfi re".
9
FIG. 6
TO MOVE FORWARD
AND BACKWARD
(See Fig. 7)
The direction and speed of movement is controlled by the
forward and reverse drive pedals.
•
Start tractor and release parking brake.
•
Slowly depress forward (K) or reverse (L) drive pedal to
begin movement. Ground speed increases the further
down the pedal is depressed.
TO USE CRUISE
CONTROL
=J (See Fig. 7)
The cruise control feature can be used for forward travel
only.
SYSTEM CHARACTERISTICS
The cruise control should only be used while mowing or
transporting on relatively smooth, straight surfaces. Other
conditions such as trimming at slow speeds may cause the
cruise control to disengage. Do not use the cruise control
on slopes, rough terrian or while trimmimg or turning.
Advertisement
