Hitachi 19VR7B Owner's Manual page 31

1 |¢+oUI_LEbHO01 iNL_ _UIDE
If you have followed the instructions contained in this manual and have difficulty in operating your TVNCR,
locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE
ACTION columns to remedy the problem.
SYMPTOM CORRECTIVE ACTION
No power. • Connect AC power cord to AC outlet.
• Set the POWER button to ON.
No picture and sound. • Plug power cord into an active AC outlet.
No picture or poor pic-
ture on TVNCR.
No sound or poor sound.
Timer recording is not •
possible.
Cannot go into Record •
mode.
Playback picture is par- •
tially noisy.
Noise in picture on play-
back.
No operation by infrared
Remote Control.
• Video heads are dirty.
• No power to TV/VCR.
• Weak batteries•
POSSIBLE CAUSE
AC Power cord is not connected. •
POWER button is set to OFF. •
TV/_/CR is not plugged into an •
active AC outlet.
Antenna is not connected. •
r+
No channel in memory. •
Direction or condition of antenna is •
not adequate.
Picture control is not adequate. •
Volume control on remote control •
unit or main unit is in minimum
position.
MUTE button on the remote control •
unit is in the ON position.
The timer recording is set incorrectly. •
The timer recording is not set to ON. •
The erase-prevention tab on cassette •
is missing.
The TRACKING control is not set •
correctly.
Check antenna Connection.
Program tuner's memory.
Adjust direction or replace antenna.
Adjust picture controls.
Adjust Volume control on remote control
unit or set.
Press MUTE button.
Set the timer recording correctly,
Set the timer recording to ON.
Place transparent tape over missing
erase-prevention tab.
Adjust TRACKING control for better
picture.
Head cleaning is necessary, consult the
nearest Service Center.
Make sure the AC cord is connected to
an AC outlet.
Check the batteries in infrared Remote
Control.
- 31 - EN
6D16