Husqvarna 917.374426 Owner's Manual page 14

GEAR CASE
o To keep your drive system working
properly, the gear case and area around
tile drive should be kept clean and free
of trash build-up. Clean under the drive
cover twice a season.
• The gear case is filled with lubricant to
the proper level at the factory° The only
time the lubricant needs attention is if
service has been performed on the gear
case.
. tf lubricant is required, use only Texaco
Starplex Premium 1 Grease, Part No.
750369° Do not substitute.
ENGINE
LUBRICATION
Use only high quality detergent oil rated with
API service classification SG-SL Select the
oil's SAE viscosity grade according to your
expected operating temperature,
...... £AE VlSCosrrY GRADES
......... ......... L ..........
TEMPERkYOR_; RANGE ANTIG'IPATED BEFOF_E,,,NEXT OIL CHANGE
NOTE: Although multi-viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity oils will
result in increased oil consumption when
used above 32°F. Check your engine oil
level more frequently to avoid possible
engine damage from running low on oil
Change the oil after every 25 hours of op-
eration orat least once a year if the mower
is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil level,,
TO CHANGE ENGINE OIL
NOTE: Before tipping fawn mower to
drain oil, empty fuel tank by running en-
gine until fuel tank is empty.
1,. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plugo
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
Container
4. Wipe off any spilled oil from lawn
mower or side of engine.
5o Slowly pour oil down the oil fill spout,
stopping every few ounces to ciqeck
the oil level with the dipstick.
6o Stop adding oil when you reach the
FULL mark on the dipstick. Wait a
minute to allow oil to settle°
7. Continue adding small amounts of oil,
rechecking the dipstick until oil bevel
settles at FULL DO NOT overfill, or
engine will smoke heavily from the
muffler on startup.
8. Always be sure to retighten oil dipstick
before starting engine.
9. Reconnect spark plug wire to spark plug.
AIR FILTER
Your engine will not tun properly and may
be damaged by using a dirty air filter.
Replace the air filter cartridge every 100
hours of operation or every season, which-
ever occurs firsL Service air cleaner more
often under dusty conditions.
TO CLEAN AIR FILTER
1_ Loosen screw and tilt cover to remove.
2. Carefully remove cartridge.
3. Clean by gently tapping on a flat sur-
face. If very dirty, replace cartridge.
&CAUTION: Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge. They may cause deterioration
of the cartridge° Do not oil cartridge. Do
not use pressurized air to clean or dry
cartridge.
4, Install cartridge, then replace cover.
Be sure tabs are aligned with slots in
the back plate, Fasten screw securely.