Lawn Mower - Husqvarna 917.374426 Owner's Manual

LAWN MOWER
Alwaysobservesafetyruleswhen per-
formingany maintenance..
Blade adapter
Lockwasher
Key
Crankshaft
<eyway
TIRES
o Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
° Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may
cause tire damage.
DRIVE WHEELS
Check front drive wheels each time before
you mow to be sure they move freely°
The wheels not turning freely means trash,
grass cuttings, etc,. are in the drive wheel
area and must be cleaned to free drive
wheels.
If necessary to clean the drive wheels, be
sure to clean both front wheels_
1. Remove hubcaps, Iocknuts & washers.
2o Remove wheels from wheel adjusters_
3. Remove any trash or grass cuttings
from inside the dust cover, pinion and/
or drive wheel gear teeth,
4. Put wheels back in place.
NOTE: If after cleaning, the drive wheels
do not turn freely, contact a Husqvarna or
other qualified service center.
BLADE CARE
For best results, blade must be kept
sharp. Replace a bent or damaged blade.
CAUTION: Use only a replacement
blade approved by the manufacturer of
your mower. Using a blade not approved
by the manufacturer of your mower is haz-
ardous, could damage your mower and
void your warranty.
TO REMOVE BLADE
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Turn lawn mower on its side° Make
sure air filter and carburetor are up.
3. Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
NOTE: Protect your hands with gloves
and/or wrap blade with heavy cloth.,
4. Remove blade bolt by turning counter-
clockwise_
5. Remove blade & attaching hardware
(bolt, lock washer& hardened washer),,
Blade
Blade
bolt Hardened
/,
washer Trailing edge
Crankshaft
TO REPLACE BLADE
1_ Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
2_ Be sure the trailing edge of blade (op-
posite sharp edge) is up toward the
engine,
3., Install the blade bolt with the lock
washer and hardened washer into
blade adapter and crankshafL
4., Use block of wood between blade and
lawn mower housing and tighter-} tile
blade bolt, turning clockwise.
Recommendedtighteningtorque:35-40ft.lbs.
IMPORTANT: Blade bolt is heat treate&
If bolt needs replacing, replace only with
approved bolt shown in the Repair Parts
section of this manual.
TO SHARPEN BLADE
NOTE: We do not recommend sharp-
ening the blade - but if you do, be sure the
blade is balanced Care should be taken
to keep the blade balanced. An unbal-
anced blade will cause eventual damage
to mower or engine,
° The blade can be sharpened with a file
or on a grinding wheel° Do not attempt
to sharpen while on the mower.
° To check blade balance, drive a nail into
a beam or wall, Leave about one inch of
the straight nail exposed. Place center
hole of blade over the head of the nail.
If blade is balanced, it should remain in
a horizontal position. If either end of the
blade moves downward, sharpen the
heavy end until the blade is balanced,
GRASS CATCHER
o The grass catcher may be hosed with
water, but must be dry when used,
o Check your grass catcher often for dam-
age or deterioration, Through norrnal
use it will wear, If catcher needs replac-
ing, replace only with approved replace-
ment catcher shown in the Repair Parts
section of this manual, Give the lawn
mower model number when ordering,
13